So I played a Kronos in the UK this week

Discussion relating to the Korg Kronos Workstation.

Moderators: Sharp, X-Trade, Pepperpotty, karmathanever

Post Reply
Jeremy Bender
Full Member
Posts: 111
Joined: Tue May 15, 2007 8:20 pm
Location: UK

So I played a Kronos in the UK this week

Post by Jeremy Bender »

I got very lucky this week and chanced upon a visit by Korg with a K61 to PMT in Birmingham.

I spent nearly an hour with it and it is truly fab! I immediately ordered an 88 and paid my deposit!

I was initially a bit disappointed with the physical look of the 61 especially the end cheeks which to meet looked a bit shiny to keep looking good and also felt a bit hollow. That said once I got playing that was forgotten

I have an M3 and the immediate thing for me was the enhanced clarity and definition in the sound on combis I know and love from that. The screen was big and clear but I do think the fonts could be bigger. However the amount of data and tabs on one page makes editing quicker and more obvious.

Two obvious questions for me. Can I use the legacy MS 20 controller via USB to control the MS20 in Kronos and can I use the pads on the M3 via midi to trigger the K as well? Obvious I am sure but any thoughts appreciated.
EvilDragon
Platinum Member
Posts: 1992
Joined: Thu Nov 24, 2005 1:18 pm
Location: Croatia

Re: So I played a Kronos in the UK this week

Post by EvilDragon »

Jeremy Bender wrote:Two obvious questions for me. Can I use the legacy MS 20 controller via USB to control the MS20 in Kronos and can I use the pads on the M3 via midi to trigger the K as well? Obvious I am sure but any thoughts appreciated.
1) I don't think so.

2) If the pads on M3 send out MIDI, then yes.
User avatar
Trinity2112
Platinum Member
Posts: 578
Joined: Wed Feb 20, 2002 5:35 pm
Location: Delaware, USA

Re: So I played a Kronos in the UK this week

Post by Trinity2112 »

Jeremy Bender wrote:I was initially a bit disappointed with the physical look of the 61 especially the end cheeks which to meet looked a bit shiny to keep looking good and also felt a bit hollow.
I was immediately disappointed with the physical appearance. The joystick, end caps and data wheel looked like they belonged on an entry level synth, not a $3000 workstation. While I could read the text fine, the buttons needed a pinpoint touch(s) before they responded, unlike the Oasys buttons which often respond with a light swipe. One thing I noticed was that the front panel, which I thought was metal, was actually warm to the touch. Which leads me to believe it was plastic.
Current Korg Lineup: Kronos 61, Oasys 76 · M3-61/RADIAS · Trinity Plus/HDR · 01/WFD · 01R/W · X3R · M3R · Wavestation EX · Wavestation SR · Triton Rack/MOSS · Z1EX · TR-Rack · Karma · D3200 · iM1 · iWavestation · iMono/Poly
Other Synths: Berhinger Deepmind 12 · iProphet · Moog Model D
Dearly departed: X3
User avatar
Kontrol49
Platinum Member
Posts: 1280
Joined: Sat Mar 04, 2006 3:03 pm

Re: So I played a Kronos in the UK this week

Post by Kontrol49 »

Trinity2112 wrote:I was immediately disappointed with the physical appearance.
Does your Oasys know your eyeing up another mistress :lol:


Why would you want a Kronos Beefburger....when you got an Oasys Steak at home?? :mrgreen:
--Korg Nautilus~~Korg Modwave--Korg SV-1-Korg Wavestate--
dustymaestro
Posts: 46
Joined: Wed Apr 13, 2011 9:34 am

Re: So I played a Kronos in the UK this week

Post by dustymaestro »

EvilDragon wrote:
Jeremy Bender wrote:Two obvious questions for me. Can I use the legacy MS 20 controller via USB to control the MS20 in Kronos and can I use the pads on the M3 via midi to trigger the K as well? Obvious I am sure but any thoughts appreciated.
1) I don't think so.

2) If the pads on M3 send out MIDI, then yes.
I think you guys can hook up some usb stuff. You need this convertor. iconnectmidi:

Image
User avatar
drchris
Full Member
Posts: 178
Joined: Sat May 21, 2011 9:10 pm
Location: Memphis, TN

Post by drchris »

Ok, my excuse is that it's late here.

I went to the iConnectMIDI site, and I don't get how this helps? Any MIDI capable keyboard (i.e. M3) should be able to connect via the MIDI out, right? Would this let you connect a NanoPad to the general MIDI in of the Kronos?

This interface is $179 - seems like its cheaper just to get gear that has MIDI out directly (i.e. AKAI MPD)

Again, maybe I'm missing the point.

Chris
User avatar
StephenKay
KARMA Developer<br>Approved Merchant
KARMA Developer<br>Approved Merchant
Posts: 2995
Joined: Tue Jun 18, 2002 2:16 am
Location: Scottsdale, AZ
Contact:

Post by StephenKay »

drchris wrote:Ok, my excuse is that it's late here.

I went to the iConnectMIDI site, and I don't get how this helps? Any MIDI capable keyboard (i.e. M3) should be able to connect via the MIDI out, right?
Correct.
Would this let you connect a NanoPad to the general MIDI in of the Kronos?
Well yes, that's the idea. You cannot connect a USB-only pad device directly to the Kronos. At least, not yet until Korg writes a driver that would allow that and bundles it into the OS.

So you could plug a USB only device into this, and get MIDI ports...
This interface is $179 - seems like its cheaper just to get gear that has MIDI out directly (i.e. AKAI MPD)
Correct again. ;) Like a Korg Pad Kontrol, which has been reported at my forums to work quite well:

http://www.karma-lab.com/forum/showthread.php?t=18135
User avatar
McHale
Platinum Member
Posts: 2487
Joined: Tue Feb 10, 2009 4:03 pm
Location: B.F.E.

Post by McHale »

StephenKay wrote:...which has been reported at my forums to work quite well:

http://www.karma-lab.com/forum/showthread.php?t=18135
Good link. There's been discussion on here as well regarding the same thing. This is the first post I've seen where someone's confirmed they got it working to take over the duty of the on screen pads.

-Mc
Current Korg Gear: KRONOS 88 (4GB), M50-73 (PS mod), RADIAS-73, Electribe MX, Triton Pro (MOSS, SCSI, CF, 64MB RAM), SQ-64, DVP-1, MEX-8000, MR-1, KAOSSilator, nanoKey, nanoKontrol, 3x nanoPad 2, 3x DS1H, 7x PS1, FC7 (yes Korg, NOT Yamaha).
User avatar
Trinity2112
Platinum Member
Posts: 578
Joined: Wed Feb 20, 2002 5:35 pm
Location: Delaware, USA

Re: So I played a Kronos in the UK this week

Post by Trinity2112 »

Kontrol49 wrote:
Trinity2112 wrote:I was immediately disappointed with the physical appearance.
Does your Oasys know your eyeing up another mistress :lol:

Why would you want a Kronos Beefburger....when you got an Oasys Steak at home?? :mrgreen:
Curiosity. And yes, she knew all about it. She's kinda "funny" that way. :wink:

I'm so happy for all the Kronos owners who get to experience that glorious sound Oasys owners have been enjoying for years. That's all that really matters in the end.
Current Korg Lineup: Kronos 61, Oasys 76 · M3-61/RADIAS · Trinity Plus/HDR · 01/WFD · 01R/W · X3R · M3R · Wavestation EX · Wavestation SR · Triton Rack/MOSS · Z1EX · TR-Rack · Karma · D3200 · iM1 · iWavestation · iMono/Poly
Other Synths: Berhinger Deepmind 12 · iProphet · Moog Model D
Dearly departed: X3
dustymaestro
Posts: 46
Joined: Wed Apr 13, 2011 9:34 am

Post by dustymaestro »

Drchris, I think it was designed mainly for the iphone, ipad connection. Its up to your imagination as to what else you could do with it.

I never knew that the Korg Padkontrol was so affordable. :)
User avatar
drchris
Full Member
Posts: 178
Joined: Sat May 21, 2011 9:10 pm
Location: Memphis, TN

Post by drchris »

While we're talking about iPad / iPhone,

It shouldn't be a problem to use software like touchAble http://touch-able.com/Site/touchable.html to connect with Ableton, and route messages to the Kronos. I particularly like the XY pad feature (http://www.youtube.com/watch?v=peG-K3F0WtQ) and think that will be really cool in controlling parameters inside the Kronos.



This may not really be possible until the VST comes out. I'll be checking into this more when my 88 comes this week.

Chris
Post Reply

Return to “Korg Kronos”