Little help please!

Kinyo · Post by **Kinyo** » Sat Mar 10, 2012 2:53 am

Ok so iv just made a pattern and i want it to loop. Now that's all fine, but the problem i have is that its a length of 4 and playing 16 beats. But on the 4th bar i want it to stop on 6th beat and keep looping

so basically : -

1-16 = bar one
1-16 = bar two
1-16 = bar three
1-6 = bar four

X-Trade · Post by **X-Trade** » Sat Mar 10, 2012 1:56 pm

So basically your loop is 54 16ths?

To do this, you'll need to change the 'last step' parameter so that you get 54 beats in total.

This affects each bar though, not just the last one. So you'll have to do some rearranging. I think if you change last step on an existing pattern it will just ignore the other steps in each bar.

If you're talking about the ESX or EMX, then you could to 6 bars of 9 16ths (54 / 6 = 9). I don't think the old ES/ER/EM/EA support the 'last step' feature anyway, and they only go up to four bars.

Kinyo · Post by **Kinyo** » Sun Mar 11, 2012 12:25 pm

This was a lot of help thanks