Page 1 of 1
A factory reset of the computer
Posted: Fri Apr 20, 2012 10:02 pm
by adamkol1
Hello! I'm from Polish.
Does anyone know if you can restore the factory settings Korg M50, from a computer? If so, I would ask for as much information as possible to do so.
By chance, bad calibration of the screen, and now the end is not working as it should. I can not press the Menu (top right), and this is needed to restore the factory settings.
Anyone know what to do in this situation?
I apologize for my mistakes.
Posted: Sat Apr 21, 2012 12:11 am
by michelkeijzers
I don't think so ... why not using a SD card?
Posted: Sat Apr 21, 2012 12:38 pm
by cymeg
power up the m50
press global
hold down "enter" and press the "3" on the num block
now you can re-calibrate the screen
Posted: Sun Apr 22, 2012 11:58 am
by adamkol1
Thank you. I have the option to enter the calibration screen, but I can just press the square in the lower right corner, but I can not press the square in the upper left corner. Why?
Posted: Sun Apr 22, 2012 3:27 pm
by cymeg
seems like the touchscreen is broken
Posted: Sun Apr 22, 2012 8:25 pm
by adamkol1
It seems to me that the display is good. Because with him all the options work, but not exactly where you need to press. In addition, the USB key plugged into the computer, and played, and I shifted all the names of the categories of sounds. It may have something in common?
I use the dictionary, so I apologize for the errors.
Posted: Tue Apr 24, 2012 3:14 pm
by cymeg
Hard Reset:
From the manual:
"If operation of the M50 should become unstable, you
can initialize it.
Turn off the power, and then, while holding down the
RESET CONTROLS switch and REALTIME
CONTROL switch, turn the power on.
The M50 will be initialized. While the data is being
loaded, the display will indicate “Now writing into
internal memory.”
note that every custom programs and combis will be lost
Posted: Tue Apr 24, 2012 8:34 pm
by adamkol1
I did a HARD RESET but it did not help. I would add that from somewhere from the larger half of the down, the display is accurate and can be accurately press, only the top of the display is not accurate.
Holding the "enter" and selecting the individual digits of the numeric keys, you can select functions from the menu. And in the global mode is the "Half Damper Calibration". What is it?
Posted: Tue Apr 24, 2012 10:32 pm
by michelkeijzers
I suggest calling Korg Support.
Half damper is a special 'switch' which has 3 states instead of two (on/off) and used for piano playing ... wikipedia is your friend.