Messed up installing EXS11, safe to reboot?

ParadoxMachine · Post by **ParadoxMachine** » Sun Jun 03, 2012 2:39 pm

Hey

While installing esx11, I accidentally disconnected the usb drive from the Kronos (it was attached to an extention cord and I moved things around), and now the installer hangs at 28%. Reconnecting it doesn't make the installer continue, so now the machine is basically stuck.

Since it's actually been writing files, I'm afraid turning it off now could cause problems.. But there's not much more I can do now, it's unresponsive (alhough I can still play a piano tune

)

What to do?

ParadoxMachine · Post by **ParadoxMachine** » Sun Jun 03, 2012 2:41 pm

Never mind, I figured rebooting was the only option anyway. Booting now, fingers crossed..

ParadoxMachine · Post by **ParadoxMachine** » Sun Jun 03, 2012 2:43 pm

Ok, everything's still fine, thank goodness

MarPabl · Post by **MarPabl** » Sun Jun 03, 2012 7:21 pm

Yes, I had multiple reboots when installing EXs12 because there was a corrupt file causing Kronos to stop responding. When you star again, the installer will overwrite the files again. Just make sure to wait 10 seconds before turning the Kronos again.