OUTPUT 1 vs L/R OUTPUT (DRUMS)

[fResH_]

Hello, can anyone explain for me why the drumkit in L/R OUTPUT sounds mutch better then the OUTPUT 1.

Its a big difference in quality. L/R gives a fat rich sound and is more plesent.. And output 1 is thin garbage sound of the drum.

Its maybe hard to hear true this clip but make a notice and listen espacially to the KICK and you clearly hear.


* They both have the same flat EQ and level


http://www.youtube.com/watch?v=0ZT2kJQ8deM

[michagi]

Maybe MAXX Audio is the case here

"MaxxEQ is a full spectrum frequency equalization, positioned at
the end of the signal chain, just before the Left & Right audio
outputs." [from the Manual]

regards
Michal

[AntonySharmman]

Hello, can anyone explain for me why the drumkit in L/R OUTPUT sounds mutch better then the OUTPUT 1.

Bypassing the whole Maxx module and all effects associated with DK then audio is equivalent at both outputs l
As michagi said under manual reference , Maxx module is used only at L/R channels , but the most important thing
for audio experts is that also Effects are totally missed when using Outputs 1/2 !

Therefore Outputs 1/2 must be used only under studio routines , or when a sound engineer is in charge for your Gigs
when external effects and processors will be applied !

[JayLou]

Very poorly designed. Why bother putting in extra outputs if your not going to allow effects to be sent to these outputs. Yamaha motif rack had the same issue which drove me crazy. M3 allows effects out on all outputs.