Prog not working after switching to Combi or Sequence

Lcash · Post by **Lcash** » Fri Jul 05, 2013 12:20 am

When I turn on my Krome 88 the Prog button lights and everything works but if I switch to Combi or Sequence it will not return to Prog. I have to reboot in order to get back to prog. Does anyone think this is hardware or software issue? Any help would be appreciated. I have owned this for about 4 months and this is the ONLY problem I have had.

Lcash

michobo · Post by **michobo** » Fri Jul 05, 2013 5:01 am

Perform a RESTORE operation (aka HardReset) if it not helps, then Korg must be go to service for repair (damaged microswitch for PROG button)

Lcash · Post by **Lcash** » Fri Jul 05, 2013 4:50 pm

michobo wrote:Perform a RESTORE operation (aka HardReset) if it not helps, then Korg must be go to service for repair (damaged microswitch for PROG button)

Thanks, that worked!