Hey guys, I'm a complete and utter newbie when it comes to this stuff. It would seem that when I configure my MS-20 Mini to the guitar synth specs in the "Setting Examples" booklet nothing comes out. I tried to adjust the signal level so that the peak indicator light would at least flash when I strum but nothing is coming through whatsoever. I am now inclined to think that my signal in jack just isn't working at all, however I am using a Stereo 1/8" male to Mono 1/4" Male, but from what I understand that shouldn't make the slightest bit of difference.
So, is there any way that I can test to see if my signal in jack even works at all? So far I have plugged an mp3 player into it as well as my monotribe output into it with nothing showing up on the peak indicator when they have both been at full volume. This is very irritating as I had just picked it up today and was looking forward to the whole guitar synthesis part of it.
Help would be much appreciated.
MS 20 Guitar/Signal in not working
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Could it be just perhaps one knob you havn't turned or something ? Check this at 2 mins 20 secs.
http://youtu.be/Dxl_ZQezVAw
http://youtu.be/Dxl_ZQezVAw
My current Korg gear. MS20 Mini... & now the .... Oh, maybe not !
...Had a few other Korg things over the years.
...Had a few other Korg things over the years.