Noob: editing voices/stops/octaves?

MmeK · Post by **MmeK** » Sun Oct 13, 2013 6:09 pm

Hi! I just bought a Triton Pro X Studio on ebay, after borrowing a friend's for way too many gigs. I'm trying to edit some programs for a theatre piece and need to emulate some accordion stops. How do I take a program with layered octaves (say the bandoneon program) and change those octaves? For instance, the bandoneon sounds like it has an 8foot reed and a 4foot reed, and I'd like to have a 16foot reed with the 4foot. How do I make that an edit (I know how to save edited programs to a bank) without involving those SW knobs? Thanks. I've been combing this and other forums, and the manual, with no luck. Only discussions of octaves seem to relate to arpeggiation.

SanderXpander · Post by **SanderXpander** » Sun Oct 13, 2013 9:44 pm

Only if those are separate samples of the 8 foot and 4 foot could you do that. You'll find it in the OSC/Basic page. Tbh I doubt they are, I don't think bandoneons have more than two reed sets and those would normally be tuned 8 4 or sometimes 8 8 musette way back when.

You could always try layering one or two presets in combi mode?