I am using a weighted keyboard to control my K61. In a combi it comes in on MIDI ch. 2. Can I/how do I get the joystick to control the sound that the external board is triggering? Sorry if this is an obvious newbie question.
Thanks for any guidance that you can provide!
motifvader
Using joystick to control program
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
motifvader
- Posts: 6
- Joined: Sat Nov 19, 2011 5:18 pm
- Location: Norristown, PA
Enable KARMA, then at the KARMA: GE Setup/Key Zones page make these settings for one module.
In channel: global channel
Out channel: channel 2
Run and Thru Inside Zone: both disabled
Now the module should take all Kronos controller data (no notes), convert to channel 2 & output to the timbre. Notes sent from the other board on channel 2 will sound the timbre.
If timbres on a certain channel stop sounding, this usually means another KARMA module has its in & out set to that channel. To correct this just change one or both to a different, unused channel.
In channel: global channel
Out channel: channel 2
Run and Thru Inside Zone: both disabled
Now the module should take all Kronos controller data (no notes), convert to channel 2 & output to the timbre. Notes sent from the other board on channel 2 will sound the timbre.
If timbres on a certain channel stop sounding, this usually means another KARMA module has its in & out set to that channel. To correct this just change one or both to a different, unused channel.
-
motifvader
- Posts: 6
- Joined: Sat Nov 19, 2011 5:18 pm
- Location: Norristown, PA