EXB-MOSS Triton Rack Error Codes

[samriccijr]

Hi MOSS list!

Does anyone have the error codes for the Tritons? They are not listed in the Triton or Z1 or Trinity service manuals that are online.....

I am also also looking for the test point destinations (which are the 16 copper dots next to the ribbon). I assume the other 6 dots are the MOSS voice outputs.

Please point me in the right direction!

I just purchased an EXB-MOSS board for my OS 1.5.2 Triton Rack.

When I install it (and Enter-0 initialize), the Triton Rack boots up and I can load programs to the F Bank. But when I try to select those programs, the Triton Rack locks up and gives no sound.

When I restart the Triton rack it locks on the "Starting System..." screen. I unplug the MOSS board and the Triton boots normally. After I wait a few hours, I plug the MOSS board back in and the cycle repeats...

When I start the the Triton in Test Mode (Enter-5) I get two error codes:

OVERLOAD NG-S1
EXB-MOSS 10-S4

I also confirmed 5VDC coming into the capacitor and some of the test ponts. One or 2 test ponts had 2.9V DC too.

Anyone seen these before?

I will try the "clean the ribbon contacts" trick.

I have solder skills and I am not afraid to replace a chip. I don't have a lot of money invested either... Please let me know if I should tinker or abandon....

Thank you,
Sam Ricci, Jr.

Prophecy (x2), Trinity Plus PBS SCSI, TR-Rack, Triton Rack, Broken Wavestation SR.....

[Ateyaboss713]

did you ever get that moss board to work?



just bought one online for my extreme and have had no luck in getting it to work.....

strangely enough it is doing the same things you describe...

i can load the moss sounds but cannot play them