|
Korg Forums A forum for Korg product users and musicians around the world. Moderated Independently. Owned by Irish Acts Recording Studio & hosted by KORG USA
|
View previous topic :: View next topic |
Author |
Message |
skilla
Joined: 13 Feb 2008 Posts: 2
|
Posted: Wed Feb 13, 2008 4:54 pm Post subject: technics -> connectiv -> KP3 -> mixer -> monitor |
|
|
When I route output from Technics 1210mk2 (playing timecoded vinyl) to M-Audio's Torq Connectiv Soundcard (4 I/O) and then to Korg Kaoss Pad KP3 the light on KP3 flashes red, which means the input volume is too high. Anybody has done this before? Please guys, if u are using above mentioned M-Audio or any kind of timecoded vinyls with Kaoss Pad, please post your setup.
Can anything bad happen if I just ignore the red light? |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|