USER GE's problem

loneguitar · Post by **loneguitar** » Sun Oct 14, 2007 9:17 pm

I posted this on the Karma forum and just wondered if anyone has noticed this problem.
I have been experimenting with the new user GE's and I created a couple of combi's with factory preset programs using 4 GE's from the USER A bank in the 4 karma modules. Everything is fine and works well but when I turn off the power after saving the combi's (I also saved all in disk mode) and turn the power back on again I lose all the GE's they revert to the default preset 0000 Arp Model 01 Up/Down and the user GE's are gone. I can get them back by loading the combi in from the HDD but they do not stay in the combi memory when the Oasys is turned off even though the USER A GE bank is in memory. I would just like to know if this is the way it is supposed to be or is this a bug. I remember reading Stephen Kay said these GE's could be used in any synth engine. This also happens when using only MOD-7 programs in the combi.
This problem only occurs in Combi Mode the USER GE in Program Mode stays in the internal memory after the Oasys is turned back on and works perfectly.

I would be grateful if you could try this and see what results you get.

Lou · Post by **Lou** » Sun Oct 14, 2007 9:40 pm

Loneguitar

see your thread at KLF

http://www.karma-lab.com/forum/showthre ... #post55865

loneguitar · Post by **loneguitar** » Sun Oct 14, 2007 9:53 pm

Thanks Lou

loneguitar · Post by **loneguitar** » Mon Oct 15, 2007 5:32 pm

I just thought I would let people know Stephen Kay has confirmed this as a bug on the Karma labs Oasys forum.