Korg Kronos sustain pedal doesn't record

richford · Post by **richford** » Sun Dec 08, 2013 1:31 pm

Ok so I notice following my previous post that sustain pedal is not working on the playback.
The info is recorded on the DAW - up down etc.. on the sustain pedal in piano roll - but it doesn't affect the playback of the Kronos.

I noticed an old post with same issue - but there is no answer there that is helpful here.

In midi Global -> Midi - the filters are all on. I don't know what Pads midi out means in the routing setup - not sure what's going on.

Any ideas? Might fix the previous issue as well...

Ksynth · Post by **Ksynth** » Sun Dec 08, 2013 9:24 pm

Perhaps you started to record the pedal too soon and you are not capturing the initial pedal on signal - the all the others become opposite?

richford · Post by **richford** » Sun Dec 08, 2013 9:38 pm

No I'm afraid that's not the answer

- as posted elsewhere it is now known only to occur if the Kronos editor is selected as a plugin - otherwise it doesn't happen

Ksynth · Post by **Ksynth** » Sun Dec 08, 2013 11:47 pm

Try putting a blank bar at the start to see if that gives the system time to respond to the signal from the pedal.

richford · Post by **richford** » Sun Dec 08, 2013 11:51 pm

No I'm afraid that doesn't help..

ashboe · Post by **ashboe** » Tue Dec 10, 2013 2:24 pm

I have hd this happen as a random thing....very occasionally this happens, but it is always down to me pressing the pedal down too soon. Does this happen when using the onboard sequencer?

richford · Post by **richford** » Tue Dec 10, 2013 7:37 pm

This is a repeatable problem - and only occurs when using the Editor. As has been suggested it's perhaps not designed to be used with the Editor as a plugin - all other setups work perfectly - only the Kronos Editor screws it up.

It's a shame but there it is - just the way it seems to be