Turning off the BPM sync within LFO programs - possible?

peasman · Post by **peasman** » Fri Jun 12, 2015 4:31 pm

Hi.

I've just upgraded from the KP2 to the KP3+ and I'm trying to recreate some of the sounds I've been using live with the KP2.

I'm wanting to use the slicer program on the KP3+ (probs LF22, but maybe LF23,24, or 25) as a freetime performance effect, but they're all BPM synced. Is there a way of turning this off so they're not BPM synced anymore?

Thanks,

Spheric El · Post by **Spheric El** » Sat Jun 13, 2015 8:35 am

No but you can use BPM as extra control over LFOs.
Shift an BPM will turn it faster. It can be useful for super fast and slow LFO s too ,which may or may not be useful to you (BPM 20-300).
Otherwise it's grid locked,but with triplets too.I found slicers to work ok for slow downs etc even with tempo sync.You could double tempo for finer control.

peasman · Post by **peasman** » Sat Jun 13, 2015 5:37 pm

Cheers for reply. Sounds fine bpm matched anyway, I just like the randomness sometimes!

peasman · Post by **peasman** » Sat Jun 13, 2015 5:38 pm

Cheers for reply. Sounds fine bpm matched anyway, I just like the randomness sometimes!

Spheric El · Post by **Spheric El** » Mon Jun 15, 2015 4:20 am

I know what you mean.I wish delays were unsynced more often on KP3 (like Smooth Delay).I recommend LFOs at 300 BPM sometimes though.