master volume ??

jimmiez · Post by **jimmiez** » Fri Aug 08, 2008 4:48 pm

I have my L/R outs connected to one amp and outs1&2 connected to another amp. When I raise the volume using the foot pedal all amps respond. However, when I move the master level slider on the Oasys,only the L/R outs respond. The volume to outs 1&2 stay the same. How do I make all respond to the master volume slider? Thanks

franzlp · Post by **franzlp** » Fri Aug 08, 2008 6:38 pm

I think the mater volume slider is linked only to the L/R outputs. You could link your L/R and your 1/2 to the same value slider controller and use it as a volume to control all volumes. Some folks may chime in on this one.

jimmiez · Post by **jimmiez** » Sun Aug 10, 2008 8:56 pm

I couldn't figure it out...could you post more details on how to do this? thanks...