Y Axis has stopped working

dyingequipment · Post by **dyingequipment** » Sun Apr 21, 2013 3:51 am

Yipes! Just when I find out I need to buy a replacement chip for my Juno, my kaoss pad starts screwing up too! It's stuck up the top and only moves left to right, there is no vertical axis action whatsoever. Tried resetting it to no avail? Any ideas?

bradkorg · Post by **bradkorg** » Sun Apr 21, 2013 8:40 am

You can try touchpad calibration, otherwise it's bad touchpad or bad touchpad cable/connector etc., disassemble kaoss and check!

For calibration instruction and touchpad issues, see:
http://www.korgforums.com/forum/phpbb2/ ... 850eaaafb1

Download the Service Manual free here: http://elektrotanya.com/korg_kp3_sm_ver ... nload.html

Chimera11 · Post by **Chimera11** » Fri Nov 07, 2014 4:03 am

It happened to me too until it went completely dead, you can view the solution here: http://www.korgforums.com/forum/phpBB2/ ... 615#438615