Kronos 61 Setlist Does Select But No Sound on First Press?

alanjpearson · Post by **alanjpearson** » Fri Sep 11, 2020 8:16 am

Hi

Just recently I have noticed two presets in the Setlist do not sound on first press but do if I press again.
Its the same two presets - which worked a couple of weeks ago - first time press does not work.
I am on 3.1.3 and haven't done any updating lately which would have caused this.

Any thoughts?

burningbusch · Post by **burningbusch** » Thu Sep 24, 2020 9:24 pm

Could be a weird glitch with patch remain. You might try disabling the FXs (saving the program). Patch remain keeps the previous programs FXs active. sp the thought is it could be related to FXs. Does it only do this transitioning from a certain program or from any/all?

Busch.

ronnfigg · Post by **ronnfigg** » Sun Sep 27, 2020 1:48 am

Not sure what you mean by do not sound on the 1st press. Are you talking about the sound of the patch changing? Or the beeping of the display when you touch it? There is a way in global mode under the page menu commands to calibrate your display.

alanjpearson · Post by **alanjpearson** » Sun Sep 27, 2020 5:49 pm

burningbusch wrote:Could be a weird glitch with patch remain. You might try disabling the FXs (saving the program). Patch remain keeps the previous programs FXs active. sp the thought is it could be related to FXs. Does it only do this transitioning from a certain program or from any/all?

Busch.

hi Busch

Its' always the same patches which select muted - it is almost like it has been muted by the prior patch.
Thanks - I'lll look at patch remain though I haven't turned anything on or off purposefully in FX

alanjpearson · Post by **alanjpearson** » Sun Sep 27, 2020 5:50 pm

ronnfigg wrote:Not sure what you mean by do not sound on the 1st press. Are you talking about the sound of the patch changing? Or the beeping of the display when you touch it? There is a way in global mode under the page menu commands to calibrate your display.

If I select the patch/slot in Setlist the patch does not play - it's not a screen calibration problem.

ronnfigg · Post by **ronnfigg** » Sun Sep 27, 2020 6:32 pm

Does it happen if you switch between the patches in their related mode i.e. Combi/Prog/Seq?

ronnfigg · Post by **ronnfigg** » Sun Sep 27, 2020 10:04 pm

burningbusch wrote:Could be a weird glitch with patch remain. You might try disabling the FXs (saving the program). Patch remain keeps the previous programs FXs active. sp the thought is it could be related to FXs. Does it only do this transitioning from a certain program or from any/all?

Busch.

"Patch remain" = SST (Smooth Sound Transition)

alanjpearson · Post by **alanjpearson** » Mon Sep 28, 2020 7:23 am

ronnfigg wrote:Does it happen if you switch between the patches in their related mode i.e. Combi/Prog/Seq?

I'll check - thanks