Sampling Mode - How do you change RAM Bank???

Wares7 · Post by **Wares7** » Tue Oct 27, 2009 4:59 pm

Hi everyone,

I hope someone can help me with the following problem on my Pa1X Pro:

In sampling mode I load a WAVE file and slice it then when i select write.
I choose the location, but then it says: "Not enough RAM for PCM".
But the problem is when i go to sampling info i can see my RAM Bank 1 is full, but RAM Bank 2 has 114s. of free space.

Does anyone know how to change to RAM Bank 2?

Please help me it's very urgent!

Wares7 · Post by **Wares7** » Wed Nov 04, 2009 11:27 am

Can someone please reply me, i need help!

milo · Post by **milo** » Thu Nov 05, 2009 11:34 am

Hi Wares,

It is simple. You don't have enough ram memory. 114 s is too low for a sample, it can't be filled.

I think that is it...

Wares7 · Post by **Wares7** » Thu Nov 05, 2009 3:40 pm

I have 114 seconds free space and my sample is 3-4 seconds, so my RAM bank 2 is not full!

Post by **karmathanever** » Fri Nov 06, 2009 1:17 am

If the OS says it is full then the OS cannot add any more to RAM.
I do not know how RAM is distributed and allocated but I would guess that this would be the reason.
RAM may be fragmented - you could save your SET, clear RAM and reload your SET - this may possibly "defragment" RAM and free up a little space.

I am guessing here - I am not familiar with the architecture of these keyboards.

Pete