So, I finally gotban iPad to read the manual, but I ran into something tonight I couldn't find.
I have a CC pedal (as in continuous "expression" pedal). I see the global setting to define it, but for horn patches, I want to have it adjust expression AND the ribbon simultaneously...doable? I figure this must have something to donwith the ams mixer that I don't fully understand yet (it's a long manual).
I'll see if I can find it in the 1500 pages...see if I get an answer here first.
Double duty pedal?
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
michelkeijzers
- Approved Merchant
- Posts: 9112
- Joined: Thu Feb 08, 2007 3:10 pm
- Location: Netherlands
- Contact:
AFAIK with an AMS mixer you can control a parameter with 2 different controllers, what you want is to control two different parameters with one controller (the pedal).
What you want is not possible directly, however suppose the ribbon controls the pitch and expression controls the volume, you have to change one of these two parameters to 'listen' to another controller, i.e. change the volume to ribbon too and then you can set the pedal to ribbon and control it both. This way you can even control 10 or 20 parameters with just one controller. And you still can use an AMS mixer to let it listen also to something else at the same time.
What you want is not possible directly, however suppose the ribbon controls the pitch and expression controls the volume, you have to change one of these two parameters to 'listen' to another controller, i.e. change the volume to ribbon too and then you can set the pedal to ribbon and control it both. This way you can even control 10 or 20 parameters with just one controller. And you still can use an AMS mixer to let it listen also to something else at the same time.
Developer of the free PCG file managing application for most Korg workstations: PCG Tools, see https://www.kronoshaven.com/pcgtools/