Red Font

Tomy · Post by **Tomy** » Wed Feb 06, 2013 7:17 pm

Hi Guys, today something strange happened. When i switch from combi mode into program mode for example in a Al-1 program some value disclosures with red numerals...

For example in AL-1 the Pulse width number is red but every other value or number is black

Did somebody know why?

Regards

Tomy

AlchemistMusicStudio · Wed Feb 06, 2013 11:20 pm

Hi Tomy!

If the Timbre’s Program uses one or more EXs Multisamples, Samples, or Drum Samples which are not currently loaded, it will not sound correctly. As an indication of this, the Timbre number’s background turns red, and the message “Samples Not Loaded” will appear at the top of the display. To fix this, load the required EXs sample data.

jerrythek · Post by **jerrythek** » Wed Feb 06, 2013 11:33 pm

He mentioned the AL-1 so it is not about samples. Parameters assigned in Tone Adjust will be red to show you they are mapped to knobs/switches/sliders.

Jerry

1jordyzzz · Post by **1jordyzzz** » Thu Feb 07, 2013 3:32 am

jerrythek wrote:He mentioned the AL-1 so it is not about samples. Parameters assigned in Tone Adjust will be red to show you they are mapped to knobs/switches/sliders.

Jerry

Nice info here!! I always thought that something went wrong in that parameter

Tomy · Post by **Tomy** » Thu Feb 07, 2013 9:33 am

Hey Guys,

thanks a lot...

So, nothing is broken

Greetings

Tomy

michelkeijzers · Post by **michelkeijzers** » Thu Feb 07, 2013 4:50 pm

jerrythek wrote:He mentioned the AL-1 so it is not about samples. Parameters assigned in Tone Adjust will be red to show you they are mapped to knobs/switches/sliders.

Jerry

Thanks ... I didn't know this either.