Assigning Midi Program Change to a combi
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
Assigning Midi Program Change to a combi
I need to assign a midi program change to the lead voice in each combi in order to utilize some off-board voicings. How is this done?
Adios, Pablo
-
michelkeijzers
- Approved Merchant
- Posts: 9112
- Joined: Thu Feb 08, 2007 3:10 pm
- Location: Netherlands
- Contact:
I'm not exactly sure what you mean with 'in each combi'.
However I think the Krome has some status settings for each timbre (part) in a combi. It can be set to:
- Off (inaudible)
- Int (default which uses then a program)
- Ext (this is probably what you need, it sends a program change to another synth which is connected to the MIDI Channel from that same timbre)
- Ex2 (not sure if the Krome has this and not sure what the difference is with Ex2, check the manual for this).
However I think the Krome has some status settings for each timbre (part) in a combi. It can be set to:
- Off (inaudible)
- Int (default which uses then a program)
- Ext (this is probably what you need, it sends a program change to another synth which is connected to the MIDI Channel from that same timbre)
- Ex2 (not sure if the Krome has this and not sure what the difference is with Ex2, check the manual for this).
Developer of the free PCG file managing application for most Korg workstations: PCG Tools, see https://www.kronoshaven.com/pcgtools/