R3: Problem with Parameter Knob Lights

alamo12 · Post by **alamo12** » Tue Jun 04, 2013 12:16 am

Hi all. I've had my r3 for about two years now and just recently the lights around the 4 parameter knob started to act odd. For example, when I turn knob 2 the lights around knob 1 move. Knobs 3 and 4 interact with each other in strange ways. The lights around knob 3 are for both knobs from values 0-68. After the parameter reaches 69, the lights around knob 4 start to illuminate. The values still go from the proper 0-127 and the correct parameter is still affected. The machine hasn't been moved from its position in the past 6 months except for a couple of books placed underneath to give it a larger angle.

I attempted a factory reset and turning the power on and off, both produced no results. Has anyone else had this problem? Does anyone have any suggestions?

alamo12 · Post by **alamo12** » Tue Jun 04, 2013 3:12 pm

randomly fixed itself overnight...

thehighesttree · Post by **thehighesttree** » Tue Jun 04, 2013 5:42 pm

Sounds really bizarre. Was it especially dry or humid? Could an issue with the insulation somewhere in the circuit between them.