Microstation 1 or 2 cable outputs

ToneM · Post by **ToneM** » Sun Mar 17, 2013 4:56 am

I currently run one cable from the left/mono output into my amp. Before I go out and buy another cable, I was wondering if putting another cable into the right output and into the 2nd. input of my amp will allow me hear the effects such as delays, chorus, etc. better. They sound fine with my headphones from the front headphone jack on the Ms but they don't sound that great with a single cable. Thanks!

Volivovej volej · Post by **Volivovej volej** » Sun Mar 17, 2013 8:09 am

It will. By using both outputs, you'll get the standard stereo sound that you can hear from your headphones.

michelkeijzers · Post by **michelkeijzers** » Sun Mar 17, 2013 2:40 pm

It depends if your amp is stereo and output to (at least) two channels (left/right).

When using one output (I think the left one), most Korg workstations automatically mix the L/R to a mono signal and output it to the Left channel.

ToneM · Post by **ToneM** » Sun Mar 17, 2013 10:51 pm

Thank's Volivovej. I will pick an extra cable!

Volivovej volej wrote:It will. By using both outputs, you'll get the standard stereo sound that you can hear from your headphones.

ToneM · Post by **ToneM** » Sun Mar 17, 2013 10:53 pm

Thanks Michel, not sure if my amp is stereo, probably not but it has two inputs with separate volume controls so I'm going to give it a try.

michelkeijzers wrote:It depends if your amp is stereo and output to (at least) two channels (left/right).

When using one output (I think the left one), most Korg workstations automatically mix the L/R to a mono signal and output it to the Left channel.