Pcgtools and Kross USB port ???
Moderators: Sharp, X-Trade, Pepperpotty, karmathanever
-
shaneblyth
- Senior Member
- Posts: 395
- Joined: Sat Mar 03, 2007 2:21 am
- Location: Queenstown, New Zealand
Pcgtools and Kross USB port ???
I want to use pcgtools installed it and the USB driver I'd like to load all my programs and combis including my custom patches in the user bank am I correct in that I have to save an all file to the sdcard and copy that to my computer and load into pcgtools do the mods then save then copy to the sdcard then load it into the Kross. I was hoping the USB port on the Kross would work and allow me to access direct from the pcgtools program but I can't see any content to load from the USB. Is this right? Also I am a bit nervous about this and I assume my process of doing this is correct?
Korg Kross 61
Casio PX-5S 88
yamaha DXR10's
Macbook Air 13"
Mainstage 3
Casio PX-5S 88
yamaha DXR10's
Macbook Air 13"
Mainstage 3
-
michelkeijzers
- Approved Merchant
- Posts: 9112
- Joined: Thu Feb 08, 2007 3:10 pm
- Location: Netherlands
- Contact:
PCG Tools does not work with MIDI (or USB mini).
You have to save a PCG file to the SD card, you load that file in PCG Tools, change it (whatever you want), save back (advised to different name) and load the file in your Kross.
You have to save a PCG file to the SD card, you load that file in PCG Tools, change it (whatever you want), save back (advised to different name) and load the file in your Kross.
Developer of the free PCG file managing application for most Korg workstations: PCG Tools, see https://www.kronoshaven.com/pcgtools/